Current Source is an adjustable, feedback (optional) current source designed to be used in the heating tests of clause 19 of IEC 60884-1
Apparatus for Checking the Withdrawal Force meets the standard of EN/IEC 60320-1, Clause 16.2, Figure 3.
Apparatus for Compression Test meets the standard of IEC 60884-1 Clause 24.5, Figure 8.
Apparatus for Flexing Test meets the standards of IEC 60320-1, Figure 7 and IEC 60884-1, Clause 23.4, Figure 21. This device is used to verify whether the flexible cable connected to the non-rewirable plugs and to the non-rewirable portable socket-outlets are made to provide protection against excessive bending where it enters the accessory
Apparatus for Impact Test at Low Temperature meets the standard of IEC 60884-1 Clause 24.4 Figure 27 and Clause 30.4 Figure 42. It is used for low temperature mechanical impact test for plugs and portable socket-outlets with enclosures, covers or bodies of by made of elastomeric or thermoplastic material. In addition, this device is also used for low temperature impact test of pin-insulating sleeves.
Apparatus for Testing Cord Retention meets the standard of IEC 60884-1, Clause 23.2, Figure 20. It is designed to test the effectiveness for cord anchorage of the accessories.
Apparatus for Verification of Maximum Withdrawal Force meets the standard of IEC 60884-1 Clause 22, Figure 18 and Figure 19. This tester is used to check whether the minimum force used to pull the single pin out of the socket-outlet with the maximum force applied to pull the plug out of the socket-outlet is within the allowed range in the standard.
Compression Test Apparatus in Hot Conditions meets the standard of IEC 60884-1, Clause 25.4, Figure 38, It is designed to test the heat resistance of the accessories
Current Source provides the required test current for heating tests in IEC 60884-1, IEC 60320-1 and similar standards.
Device for Testing Non Solid Pins meets the standard of IEC 60884-1, Clause 14.2, Figura 14. It is designed to verify the mechanical strength of non-solid pins.
Device Plug Crushing Tester, It is designed to test the resistance of the device plugs mounted on the device in accordance with the requirements of TS EN 60320-1 Figure 20.
Electrical Indicator is designed to show if there is contact with the sections related to the IEC 61032 B test probe during the Test of the Protection Against Electric Shock as specified in Article 10.1 of IEC 60884-1.