Previous product
cylindrical rod with hemispherical end for
Cylindrical Rod With Hemispherical End For
Back to products
Next product
scratching tool tip
Scratching Tool Tip
blender probe
Click to enlarge

Blender Probe

Blender Probe meets the standard of IEC 60335-2-14 Clause 20.102. The probe is designed to test whether the hand-held blenders are fully protected from the top of the blades and that the blades contact a flat surface while rotating.

Teklif Al
SKU: MT- I24E Category:
Description

Test Procedure:

This rod is applied from any position between the vertical and an angle 45 ° to the upperside of the blending blade.

It shall not be possible to touch the blades with the end of the test rod.

 

Technical Parameters:

Model MT- I24 Cylindrical Rod
Rod diameter Ø 8,0 mm ± 0,1 mm
Rod Length 80 mm (Length depends on customer request)
Reviews (0)

Reviews

There are no reviews yet.

Be the first to review “Blender Probe”

Your email address will not be published. Required fields are marked *

Related products

test finger nail
test finger nail
Close

Test Finger Nail

Test Finger Nail device meets the standard of EN/IEC 60335-1 Clause 22.11 Figure 7.
Read more
Quick view
test probe 41
Close

Test Probe 41

Test Probe 41 meets the standard of EN/IEC 61032 Clause 6.2.4.a, Figure 16. It is intended to verify the protection against Access to glowing heating elements. Relevant standards: EN/IEC 60335-1, Clause 8.1.3;
Read more
Quick view
ul accesibility probe
ul accesibility probe
Close

UL Accessibility Probe

UL Accessibility Probe meets the standards UL 474 Figure 5. 1, UL 507 Figure 9. 2 (pa100a), UL 982 Figure 7. 1, UL 1017 Figure 2, UL 1062 Figure 1. 2, UL 1278 Figure 8. 3, UL 1310 Figure 16. 2, UL 6500 Figure 14, UL 60065 Figure 14 ve UL 60950 Figure NAF. 1.
Read more
Quick view
test probe for fixed fans
Close

Test Probe for Fixed Fans

Test Probe for Fixed Fans meets the standard of UL 507 Figure 8. 2 (S2140a). It is used for fan propellers and other moving parts of stationary fans and fans intended to be permanently connected to fixed wiring.
Read more
Quick view
test probe with force
test probe with force
Close

Test Probe With Force

Test Probe With Force meet the standard IEC 60884-1 Clause 10.5, Figures 9 and 10. It is designed to test whether the live parts of the shuttered socket-outlets are accessible.
Read more
Quick view
cone a
cone a
Close

Generator A Cone

Generator A Cone is designed according to TS EN ISO 8528 Figure 1 to be used in generator tests.
Read more
Quick view
small test pin probe
small test pin probe
Close

Small Test Pin Probe

Small Test Pin Probe meet the standards BS1363-1 Clause 12.6.1 Figure 1 and IEC 60065 Annex B. It is used to test for the electronic equipment to see whether the hidden dangerous parts of the terminal device of can be touched.
Read more
Quick view
young adult arm test
young adult arm test
Close

Young Adult Arm Test Probe

Young Adult Arm Test Probe meets the standards of EN 50636-2-100 Figure 1 and IEC 50636-2. It is used to simulate the young adult to test whether the hazardous parts can be touched.
Read more
Quick view