Showing 1–12 of 47 results

Flame Height Gauge | MTNFEM

Flame Height Gauge | MTNFEM; Flame height gauge.

Flame Height Gauge | MTNFEM-1

Flame Height Gauge | MTNFEM-1; Flame height gauge.

Flame Height Gauge | MTNFEM-2

Flame Height Gauge | MTNFEM-1; Flame height gauge.

Magneto Telescopic Led and Acoustic Stanka 36kV | MT-36S

It helps to understand whether there is energy in places (money and power lines) energized by high voltage energy.

Mechanical Boden Caliper | MT-2732

Mechanical Boden Caliper | MT-2732; It is a type of caliper that measures the amount of wear of train wheels.

Sharp Edge Tester | MT-UL1439

Sharp Edge Tester | The MT-UL1439, meets international standards set by UL and the Consumer Product Safety Commission if you are concerned about the safety and sharpness of your product.

Splash Test Apparatus | MT-TD89

Splash Test Apparatus | MT-TD89; is designed and manufacture according to IEC60335-2-89 clause 15 figure 101 and other similar international standards. It is used for for testing refrigerating appliances and consists of the vessel, removable bridge support, release pin, and displacement block.

Blade Shaped Probe

Blade Shaped Probe meets the standard of UL 749 Figure 3(SB0504A). This probe is designed for household dishwasher protective testing.

Blender Probe

Blender Probe meets the standard of IEC 60335-2-14 Clause 20.102. The probe is designed to test whether the hand-held blenders are fully protected from the top of the blades and that the blades contact a flat surface while rotating.

Blender Test Probe

Blender Test Probe meets the standard of IEC 335-2-14 Clause 20.2. This probe is designed to test access to the moving parts of the Blenders.

Boden Caliper

Boden Caliper is a type of caliper that measures the wear amount of the train wheels. It can make three measurements at the same time. Supplied with gauge and bag. Has a digital display.

Cone Probe for Heating Element

Cone Probe for Heating Element meets the standard of UL 1278 Figure 10.1.