IPX3 and IPX4 Rain Test Chamber | MTBR-500K

 IPX3 and IPX4 Rain Test Chamber | MTBR-500K; has been designed and manufactured in accordance with IPX3 and IPX4 protection degree requirements according to TS 3033 EN 60529, Article 14.2.3 and Article 14.2.4, Figure 4. It is used for resistance tests of electrical devices against harmful water ingress.

DEVICE INTRODUCTION VIDEO

Order Now
Description

 IPX3 and IPX4 Rain Test Chamber | MTBR-500K; (with swivel tube and right angle tube) is used to test electrical and electronic equipment by simulating natural precipitation by spraying water from water holes on swivel tube or straight tube. It predicts and recognizes whether the cover or seals of this device will maintain a good working condition during and after testing.

MTBR-500K; It is widely used in electrical, electronics, automobile, motorcycle, electrical appliances, electromechanical equipment, instruments and meters and other industries.

 

TECHNICAL PARAMETERS

Workroom dimensions (cm) 80*80*80
Exterior dimensions (cm) 102*136*156
Power 2.0(KW)
Water spray ring radius 375 mm
Water pipe diameter φ16mm
Spraying hole diameter φ0.4mm
Aperture spacing 50 mm
Swing range ±45°, ±60°, ±90°, ±180°
Test bench rotation speed 1r/min, or steeples speed regulating (optional)
Swing speed adjustable
Raining pressure 80KPa, adjustable. (Meet 5±2 mm/min of rain density, according to standard calculation)
Rotate speed of holder 1 ~ 3r/min, adjustable. (changeable following special requirement). Can make an angle of 45°
Area of holder Ø600mm
Power supply AC 380V±10%; 50 Hz
Ambient temperature & humidity +5℃~32℃ ≤85%RH
Remark: The water for raining should be filtered soft water or purified water, to prevent the raining holes from blocked.
Reviews (0)

Reviews

There are no reviews yet.

Be the first to review “IPX3 and IPX4 Rain Test Chamber | MTBR-500K”

Your email address will not be published. Required fields are marked *