VLF Cable Tester 60 KV is intended for use in low voltage cables and generator tests.
The above information describes VLF Cable testing, where the intent of the test is to apply a sufficient test voltage for a long enough time to permit any severe defects driven into partial discharge to fail within the test duration. If a defect can’t withstand the test voltage, let it fail and make the repair or replacement. If the cable holds, the operator has a high assurance that the cable should not fail in service for many years.
VLF Cable Tester 60 KV Technical parameters:
Model | Max. Voltage | Range | Weight | Purpose |
MT-30 | 30KV | 0.1Hz, ≤1.1μF | Controller: 4 kg
Booster: 25 kg Dimension: L * W * H 323 * 174 * 323 |
10kV; For low voltage cable and generator. |
0.05 Hz, ≤2.2μF | ||||
0.02Hz, ≤5.5μF | ||||
MT-50 | 50kV | 0.1Hz, ≤1.1μF | Controller: 6 kg
Booster: 45 kg Dimension: L * W * H 357 * 210 * 365 |
15.75kV; For low voltage cable and generator. |
0.05 Hz, ≤2.2μF | ||||
0.02Hz, ≤5.5μF | ||||
MT-60 | 60KV | 0.1Hz, ≤1.1μF | Controller: 6 kg
Booster: 50 kg Dimension: L * W * H 357 * 220 * 370 |
18kV; For low voltage cable and generator. |
0.05 Hz, ≤2.2μF | ||||
0.02Hz, ≤5.5μF | ||||
MT-80 | 80kV | 0.1Hz, ≤1.1μF | Controller: 8 kg
Booster: 90 kg Dimension: L * W * H 357 * 240 * 390 |
35kV; For low voltage cable and generator. |
The components of the device are shown below.
Reviews
There are no reviews yet.