Frequency Response Analyzer
Features:
- Using the advanced technical of DDS
- Using the high speed and advanced microprocessor to design
- Using double channels of AD chip of 16 bits
- With seven inch LCD touch screen of which the brightness can be adjusted
- With thermal printer of which the print thick can be adjusted
- It could store one hundred and twenty groups of data, which could be read to current screen or upload to the PC
- With PC software using which we could upload data, test, analyse data, print data, or create word document
- Using USB2.0 to connect to the device
- Tester dimension:31cm X 15cm X 15cm
- Weight:4.0KG
Technical Parameters
- Two different sweep modes:Linear sweep and Section sweep
- Linear sweep: 0.5 kHz-1MHz ; interval 0.5 kHz, 2000 dots
Section sweep: 50Hz-100Hz; interval 2Hz, 25 dots
100 Hz-1 kHz; interval 20Hz, 45 dots
1 kHz -10 kHz; interval 50Hz,180 dots
10 kHz -100 kHz; interval 0.2 kHz, 450 dots
100 kHz – 500 kHz; interval 0.5 kHz, 800 dots
500 kHz – 1000 kHz; interval 1 kHz, 500 dots - Test range:(-100dB) – (+20dB)
- Test accuracy:1dB
- Frequency accuracy:<0.01%
- Signal input impedance:>1M Ω;
- Signal output impedance:50 Ω
GENERAL INFORMATION
What is Frequency Response Analysis?
Frequency response analysis (commonly referred to as FRA or SFRA) is a powerful and sensitive method for testing the mechanical integrity of transformer cores, windings and press frames in power transformers.
In Which Situations Is Frequency Response Measured?
We recommend testing the frequency response, especially after the following situations:
- After the transport of transformers
- After faults occur at high currents
You can use our MTKZ-902 Frequency Response Analyzer to check if the windings are damaged and then start any other actions that may be necessary.
Reviews
There are no reviews yet.