Test Device Accessories High-voltage cable, high-voltage gun, high-voltage probe, current pliers, connector, clips, crocodile tongs, resistance box etc.
Reviews (0)
Be the first to review “Test Device Accessories” Cancel reply
Related products
Crocodile Mouth Current Clamp | 200 A
Crocodile Mouth Current Clamp | 200 A is a perfectly designed accessory for test equipment that can be used in high current connections up to 200 Amp.
Shunt Resistance
Shunt Resistance is a type of resistor that allows a large portion of the current to be measured to pass over the measuring instrument when we want to measure a large current.
Thermocouple to Measure Glow Wire Tip Temperature
Thermocouple to Measure Glow Wire Tip Temperature accessory meets the standard of EN/IEC 60695-2-10 Clause 4.3. It is designed to measure the tip temperature of the glow wire.
The Clip With Crocodile Tooth | 30 A
The Clip With Crocodile Tooth | 30 A is a perfectly designed accessory for test equipment that can be used in high current connections up to 30 Amp.
Silver Foil
Silver Foil accessory meets the standard of EN/IEC 60695-2-10, Clause 5. This is used to verify the glow wire tip temperature.
Crocodile Mouth Current Clamp | 300 A
Crocodile Mouth Current Clamp | 300 A is a perfectly designed accessory for test equipment that can be used in high current connections up to 300 Amp.
High Voltage Cable
High Voltage Cable These silicone rubber insulated cables are designed to be used in high voltage tests of 2 kV, 5 kV, 10 kV, 20kV, 30kV, 40kV, 50kV.
Copper Block for 500W Flame Verification
Copper Block for 500W Flame Verification meets the standard of IEC 60695-11-3 Clause 4.2.5, Figure 2. It is supplied with 0.5 mm outer diameter, mineral insulated thermocouple.
Reviews
There are no reviews yet.