Blender Probe
Blender Probe meets the standard of IEC 60335-2-14 Clause 20.102. The probe is designed to test whether the hand-held blenders are fully protected from the top of the blades and that the blades contact a flat surface while rotating.
Description
Blender Probe (Blender Test) meets the standard of IEC 60335-2-14 Clause 20.102. The probe is designed to test whether the hand-held blenders are fully protected from the top of the blades and that the blades contact a flat surface while rotating.
Test Procedure:
This rod is applied from any position between the vertical and an angle 45 ° to the upperside of the blending blade.
It shall not be possible to touch the blades with the end of the test rod.
Blender Probe Technical Parameters:
Model | MT- I24 Cylindrical Rod |
Rod diameter | Ø 8,0 mm ± 0,1 mm |
Rod Length | 80 mm (Length depends on customer request) |
Reviews (0)
Be the first to review “Blender Probe”
Related products
Blender Test Probe
Surface Temperature Probe
Telecom Test Prob
Test Probe 18 and 19
Test Probe 18 and 19 meet the standard of EN/IEC 61032 Clauses 6.2.2.f and 6.2.2.g, Figure 12 and Figure 13.
- Test probe 18 is intended to simulate Access to hazardous parts by children of more than 36 months and less than 14 years.
- Test probe 19 is intended to simulate Access to hazardous parts by children of 36 months oe less.
Relevant standards: IEC 60065, IEC 60335-1,
Reviews
There are no reviews yet.